Attach a Morakniv Dangler to Your Belt

Quick answer

Attach the Morakniv Dangler 10 to your belt by looping the leather strip through your belt, then snap the button onto your knife sheath. This extends the sheath below your belt for easier access and reduced bulk.

Steps to attach the Morakniv Dangler 10

1. Step 1: Thread the dangler onto your belt: Slide the leather loop of the Dangler 10 over your belt. Position it where you normally carry your knife – typically on your dominant hip or just behind it. The dangler should hang freely without twisting. Make sure the leather is not twisted; a twisted dangler will cause the sheath to sit at an awkward angle.
2. Step 2: Snap the button onto your knife sheath: Line up the button on the dangler with the corresponding hole on your Morakniv sheath. Press firmly until you hear or feel it snap into place. The sheath should hang vertically below the dangler. If the button feels loose, check that you are using a compatible sheath. The dangler is designed for specific models like Finn, Wit, and Lok.
3. Step 3: Test the draw and retention: With the knife in the sheath, practice drawing it a few times. The dangler should allow a smooth pull without excessive resistance. The sheath should stay in place when you walk or bend over. If the sheath swings too much, adjust the belt position or consider a tighter belt. A loose belt will cause the whole setup to shift.

Product used in this guide

• Dangler 10 w/ Button, Black: 100 mm long and 20 mm wide, made of vegetable tanned leather with a button that connects with Finn, Wit, Lok, and several Morakniv knife models. The length gives enough drop for comfortable carry, and the leather is durable enough for regular use without adding unnecessary weight.